Replacing a shampoo bowl faucet involves removing the old faucet and installing a new one. Follow these steps:

Tools & Materials Needed:

• Adjustable wrench
• Basin wrench (optional)
• Plumber’s tape (Teflon tape)
• Bucket or towel (to catch water)
• New shampoo bowl faucet

Step 1: Turn Off Water Supply

• Locate the water shut-off valves under the sink and turn them off.
• If there are no shut-off valves, turn off the main water supply.
• Open the faucet to release any remaining water.

Step 2: Disconnect Water Supply Lines

• Place a bucket or towel under the connections.
• Use an adjustable wrench to loosen and disconnect the hot and cold water supply lines.

Step 3: Remove the Old Faucet

• Look underneath the sink for the mounting nuts securing the faucet.
• Use a basin wrench or an adjustable wrench to loosen and remove them.
• Lift the old faucet from the shampoo bowl.

Step 4: Install the New Faucet

• Position the new faucet into the existing mounting holes.
• Secure it from underneath using the provided mounting nuts.
• Hand-tighten first, then use a wrench for a snug fit (do not overtighten).

Step 5: Reconnect Water Supply Lines

• Wrap plumber’s tape around the threads of the faucet connections.
• Attach the hot and cold water supply lines to the corresponding inlets.
• Tighten with a wrench.

Step 6: Turn On Water & Check for Leaks

• Turn on the water supply valves.
• Slowly open the faucet to let water flow and check for leaks.
• Tighten any connections if necessary.

Step 7: Test the Faucet

• Ensure both hot and cold water are working properly.
• If there’s low pressure or uneven flow, check for debris in the aerator and clean it.

You’ve successfully replaced your shampoo bowl faucet